CVRick 42 Posted January 11, 2016 The shift lever made a tiny hole in the stator cover. I am going to replace it. Has anyone used A stronger cover? Thinking of upgrading the clutch side also. Has anyone used the trail jammer cover? Share this post Link to post Share on other sites
TrophyHunter 15 Posted January 11, 2016 I have a TJ on my WR but haven't put it to the test. It'd take a lot to puncture it. The fit was perfect. Share this post Link to post Share on other sites
Dress4Less 162 Posted January 11, 2016 I also have a TJ on my WR...fits great and sure is shiny when polished up! Share this post Link to post Share on other sites
CVRick 42 Posted January 12, 2016 Hinson I will look for the Hinson. Thanks Share this post Link to post Share on other sites
CVRick 42 Posted January 12, 2016 HinsonI will look for the Hinson. Thanks I could not find the shift lever side cover from Hinson. Share this post Link to post Share on other sites
Spaugh 1 Posted January 12, 2016 Oh my bad, was thinking clutch cover. Mahalo concepts or ktm hard parts for the ignition covers. Share this post Link to post Share on other sites
Spaugh 1 Posted January 12, 2016 Nihalo concepts. Something like that. Hawaiian Share this post Link to post Share on other sites
CVRick 42 Posted January 12, 2016 Nihalo concepts. Something like that. Hawaiian OK I will check. I guess this problem is not super common yet. A better bash plate is on my wish list . Many any options are available for better skid plates Share this post Link to post Share on other sites
Spaugh 1 Posted January 13, 2016 If the back side of the shifter has a pointed knife type edge, you should get out the grinder and grind it flat with rounded edges. Those big bore bikes don't have good clearance there and it does happen. Share this post Link to post Share on other sites
CVRick 42 Posted January 13, 2016 If the back side of the shifter has a pointed knife type edge, you should get out the grinder and grind it flat with rounded edges. Those big bore bikes don't have good clearance there and it does happen. Yes i am going to grind the knife edge . The clearance is super tight. Share this post Link to post Share on other sites
