robertaccio 406 Posted October 6, 2018 http://www.carbonuparmor.com/clutch-cover/ Share this post Link to post Share on other sites
Bagstr 287 Posted October 6, 2018 Whoa Dude! I know a guy who can use one of those. The product looks as if it could survive multiple drunken oil changes. Sent a message to Slaven's requesting intel on alternator side covers. Share this post Link to post Share on other sites
SoCalMule 106 Posted October 6, 2018 Looks wider than the stock cover; but the bolt pattern was not the same as the stock cover. May add more oil capacity, but may need to widen the break arm distance. Any ideas? Share this post Link to post Share on other sites
Bp619 104 Posted October 6, 2018 Probably same size as rekluse cover which adds almost .2litre and still fits well with no mods to brake lever Share this post Link to post Share on other sites
SoCalMule 106 Posted October 6, 2018 1 hour ago, Bp619 said: Probably same size as rekluse cover which adds almost .2litre and still fits well with no mods to brake lever Thanks Bp619! Share this post Link to post Share on other sites
robertaccio 406 Posted October 6, 2018 The only thing I don't like is using the gasket instead of an o ring in groove seal. Also use your torque wrench you can bet the seal surface will be tight at the fasteners and less between especially if you over tighten the fasteners causing uneven mating surfaces from cover flex. Share this post Link to post Share on other sites
Bagstr 287 Posted October 6, 2018 Jeff got back to me regarding alternator side case; " Dave: My guess is it will be a while. Each mold cost $80,000 and they have made three so they need to sell what they have to get some money back in the bank. " Share this post Link to post Share on other sites