DavidSchaffer 0 Posted October 24, 2017 I have a 2006 R1200 GS that after a 3000 mile ride started to stall after 20-30 seconds when starting it cold. When it gets to be fully warm it will keep running and start without an issue. Looking for and hoping for some help with a GS911 code reader in the San Diego area to see if I can pin point the problem It has 73,000 miles on it and these are the things that already have been done TB synced Valve Clearances TPS checked Air Filter Battery Injectors CC bypassed compression New spark plugs new o2 sensor have done the reset procedures (open close throttle/battery disconnect and ecu cleared) had a private shop check for codes and there was nothing Some other suggestions have been: Crankshaft sensor IAC sensor TPS sensor Thanks! Appreciate any input or wisdom, Share this post Link to post Share on other sites
PastaPilot 17 Posted October 27, 2017 Is that something new that it's doing after 73000 miles or have you only had it for 3000? MyAprilia does that drill when started cold. I would just give the idle speed a adjuster a turn when cold starting and then when it's warm and the engine idle speed creeps up I give it a turn back. Sorry I'm not familiar with the BMW but the Aprilia is a twin. Share this post Link to post Share on other sites